Greetings, I am new to the site, and also to the printing industry. This is the issue I’m facing: The imprints from my two-color offset machine...
So got a new kind of job in, runs simplex on preprinted shells, 9.25 x 17.25" Feeder A1 lower has the paper jumping inboard/outboard by a...
Hi All, We have had a DP60 for many years now and have also grown with the machine too but as time passes she is getting more older and had mor...
I have never seen a riso up close so I don't know much about them. I print ballots for our county, on 8.5 x 17, 90 index preprinted with...
I have a 2 color press and unit #2 prints longer than unit #1 but only on the non-operator side...the marks on the operator side are dead...
Hi there -- We are a chocolate company that does lots of short runs of labels and would like to print them in house, but at high quality. We...
I have to run a three color job where the two colors are inside a black 1 pt. border. To test the registration I run about 12 sheets through and...
On my friend DI-Classic, is the problem with bad register on black plate. When we develop the plates, black is out of registration..... any...
I need Any possible help I work on Heidelberg GTOZPS 52-2 My problem is when I installed plates I find deviation in printing from the second...
Hi We started to have registration problem with our air fed-folder some time ago. I remeber that when it frist got here, registration was...
Hi, We currently use a Xerox 7750 in our copy shop - printing flyers, business cards, photo books etc. However, I find the front to back...
hi again davor i do the registration again of the 3 yellow rollers form to the plate. 1. i do the 2 rollers form plate to 3-4 mm,and the third...
I know this sounds stupid. I cant seem to get the machine to register single colour work(book work ncr). I tried doing what the book says but...
Hello, I am using a ryobi 524 H and i have a problem The black print is double imaging as it goes through the other units when i am printing...
The customer expectation document doesn't set much of an expectation for accurate registration within +/- 1.5mm lead edge and +/- 1.7 mm side...
I am having problems with registration. Forced registration(05-407) has produced no results. Change registration motor with no results. Last thing...
I am suffering from some very severe registration problems on this unit, the colours are at least 3-4mm out from each other at even intervals....
hey, i need help on fixing the registration of my print. no matter how much i adjust the x and y on the printing adjust menu the...
I am needing help in amking color registration on 4 color jobs on a 2 color press, can any one give me some insight on this subject. I am use to...