Speed Error

Is the main drive belt slipping at all ? Does the belt squeek on start up.

Regards.
 
    • It squeaked a little, but the belts seem OK. When I jog the press continuously I get a slight hesitation about every fifth revolution.
    I appreciate your help!
     
    Look at the sensor at the delivery, once we have this problem at it was this.
     
    Thank You!!!!!!!
    I tried a little belt dressing and it worked!!!!
    I will probably need a new belt in the future!!!!
    Again, THANK YOU!!!!!!!!!
     
    I'm getting this error again, and I tightened up both belts, and disconnected the delivery sensor but still getting error message. Any suggestions!?
    Thank you!
     
    I am getting the Speed Error again. I tried to disconnect the delivery sensor, but it is still happening.
     
    Probably still motor / motor board or belt related.
     
    does the compressor kick on just before it stops imaging? if yes try turning your air up slightly but stay in the green. also check your y7 plug
     
    you have to proceed speed auto adjustment.
    run 10.000, go 3+7 and SF93.
    Switch on and off the press run until the speed on your display is close to 10.000
    (200 tolerance).
    rgds.
    Jan
     
    First I would have to ask why you want to disconnect the delivery sensor.
     
    Im having problem with my delivery table,i am able to put it higher but it wont go down and i think mayb the sensor is stopping it im not sure??
     
    Sf 71 speed adjustment ?????
     
    sorry I think it is SF 91 not sure?
     
    Anthony, it's another press. Jedo has Karat46 not QM DI. Forget SF71 and 91.
    Jan
     
    • ok....I was not paying attention......thanks....
     
    qmdipress1 said:
    ok....I was not paying attention......thanks....
    Click to expand...

    Come on Anthony, we are not going to let you keep sitting in the front of the class if you don't pay more attention. LOL
     
    You must log in or register to reply here.
    Forum posts represent the experience, opinion, and view of individual users. The Color Printing Forum does not necessarily endorse nor share the view of each individual post. When making any potentially dangerous or financial decision, always employ and consult appropriate professionals. Your circumstances or experience may be different.

    Similar threads

    QM DI Speed Error
    Replies
    4
    Views
    2,391
    CHOCK
    CHOCK
    Bill Borcicky
    speed error
    Replies
    1
    Views
    2,133
    Bill Borcicky
    Bill Borcicky
    speed error....
    Replies
    3
    Views
    2,945
    qmdipress1
    QuickMaster Classic - Speed error
    Replies
    3
    Views
    3,330
    jan
    hoshyar
    qm di stop S above the speed 6400
    Replies
    7
    Views
    2,677
    Paul Cavanaugh
    Paul Cavanaugh
    Back
    Top