Speed Error

I am receiving a Speed Error during imaging, and press keeps stopping.
Any suggestions?
Thank you!

 

Is the main drive belt slipping at all ? Does the belt squeek on start up.

Regards.

 

It squeaked a little, but the belts seem OK. When I jog the press continuously I get a slight hesitation about every fifth revolution.
I appreciate your help!

 

Look at the sensor at the delivery, once we have this problem at it was this.

 

Thank You!!!!!!!
I tried a little belt dressing and it worked!!!!
I will probably need a new belt in the future!!!!
Again, THANK YOU!!!!!!!!!

 

Thank you for your help!!!!!!!

 

I'm getting this error again, and I tightened up both belts, and disconnected the delivery sensor but still getting error message. Any suggestions!?
Thank you!

 

I am getting the Speed Error again. I tried to disconnect the delivery sensor, but it is still happening.

 

Probably still motor / motor board or belt related.

 

does the compressor kick on just before it stops imaging? if yes try turning your air up slightly but stay in the green. also check your y7 plug

 

you have to proceed speed auto adjustment.
run 10.000, go 3+7 and SF93.
Switch on and off the press run until the speed on your display is close to 10.000
(200 tolerance).
rgds.
Jan

 

How do you disconnect the delivery sensor?

 

First I would have to ask why you want to disconnect the delivery sensor.

 

Im having problem with my delivery table,i am able to put it higher but it wont go down and i think mayb the sensor is stopping it im not sure??

 

Sf 71 speed adjustment ?????

 

sorry I think it is SF 91 not sure?

 

Anthony, it's another press. Jedo has Karat46 not QM DI. Forget SF71 and 91.
Jan

 

ok....I was not paying attention......thanks....

 

Come on Anthony, we are not going to let you keep sitting in the front of the class if you don't pay more attention. LOL