XPE-10-4117 and 4118

[RMiGen]

EDIT: Solution on next post.

4117 is a Press Fault: Restart the Press

Restarting does not solve this problem.

4118 is "External Roll 1 Undertemperature in Print"

I've tried going in under service diagnostics and then Component Control>Fuser Lamps to see if disabling them would allow it to warm up. It did for a moment but then the press fault returned.


My guess is I'm SoL as it may be bad bearings, bad lamp, etc. which I am uncomfortable fixing myself.

The wait for the tech begins. Placed my call at 4pm last night and they said I wasn't even first on the list for this morning.

Joy.

 

[RMiGen]

Mounting bracket on external heat roll is broken. That should solve the problem.

Tech is going to another client to get one and will be back to replace it.

 

[igensam]

I just got the same faults that wouldn't clear. Turned out to be a bad thermistor on the top heat roller. Switched it out and press working again.

 

[Printerdroid]

It works!!

Thank you for the fix!

I had the very same problem: replaced the thermistor assembly and away it went.

I believe it was part #130K74530.

 

[wengsky]

success!!!

Thanks for tip guys, I did replaced the thermistor (part #130K74530) and now its finally running, w/out this thread I'll be waiting for like forever coz the operator sez there's six call ahead of me. anyhow. thanks again.