Ryobi offset printing machine 920/5 colour

[Ikes Sheik]

Hi all,we have a 5 colour Ryobi (920 series) and whilst printing or on normal crawl the press stops.On viewing the service screen i can see a stop button error on the delivery panel. I removed the stop button yet the error still comes up,how is this possible and what can i do to fix this problem. Please help as i am going crazeeeee!!!!

 

[Kelsey Holt]

My guess is it’s a circuit on the catwalk or gates. Our 9 series will do this from time to time.

 

[Ikes Sheik]

Thank you for your input. I will definitely have a look at this.Will keep you posted.

 

[Ikes Sheik]

Hi. I am still experiencing this problem, my 925 keeps stopping on crawl and during production. AT times it wont allow me to inch as well. A new board was purchased from Ryobi Japan this was swapped with the old one and i still have no joy.
SOMEBODY PLEASE HELP!!!!!!

 

[jwe]

could a delivery gripper bar be hitting a bad sheet sensor?

 

[Ikes Sheik]

Hi there,thank you for your valuable advice.
I checked all sensors and went through all the grippers throughout the machine and all is clear.
I am going crazeeee!!!!

 

[jwe]

if it shows a stop button in the delivery, then its something there. Could it be the last unit blanket jam detector?

 

[Ikes Sheik]

I will check that and let you know.
The funny thing is i disconnected the stop button at the delivery and the error still shows me a stop button error at delivery.
Its not the red stop button error but the other inch button, the one that flashes red.
Just a question?
What does the black air pipe do the one connected to the sheet travel jam at delivery.
Thanks again.

 

[jwe]

Its the blow down air on the sheet. Maybe check and see if your delivery chains are loose. When mine are the gripper bars hit the sheet travel jam in the delivery.

 

[CHOCK]

Hi sir:
Will be a good idea
1) By pass all sensors and stop button 1 by 1 in the Delivery.
2) if the problem persist, will be the gripper bar loose, retight the Bar grippers, and Lube chain

 

[Ikes Sheik]

Hi fellow printers, i have bypassed all emergency stop buuttons,still no luck
If the gripper bars are loose and it hits the sheet travel jam ,Will the stop button error come up on the work station.

 

[jwe]

im on a ryobi3304HA. It doesent show a stop button it shows on on the display of overtravel in the delivery.

 

[Sandman]

Hi Iam on a 755. Have u cheked the sensor in the delivery just behind the break. You will see it in the middel. When I get simlar problems I clean this and all is ok. Good luck