problem with stripes Ryobi 3304HA

[John Zidek]

Hi,

I replaced the parts on all the colors: 53 40 51 821-shaft, 53 40 51 435-3-bushing. After replacing them on the first and third tower, it makes streaks on the sheet, I’m sending a photo attached to the paper. On the paper, only one streak prints. Could you please advise me where the problem might be? Thanks for any advice.

 

[seanryder]

This looks like a single color job? If it is look at the third(lower) ink form roller. Kind of looks like the form to oscillator pressure
is light and the roller may be slipping. My first go to is just to turn it off at the night latch and see if there are any changes for the better.

 

[John Zidek]

Thanks for the reply, it's printed in CMYK, but in this case it only does black. I've checked the settings on all the rollers, on the blanket I have 3 lines... I'll try turning it off like you said...