Polar 115 emc - hydraulic press & cutting part

[Junus]

Dear all,
is there anybody know what's the voltage specification for hydraulic press & cutting solenoide at Polar 115 EMC ??
From wiring diagram, there's +42Vdc for activation hydraulic control system but there's no detail information for each press & cutting hydraulic solenoide where the signal comes from KK module and looks like the voltage control comes from CT1 & CT2.
Try bypassing with directly injected +42Vdc to each solenoide, it's work but I have to make sure it's safe ? Please advice guys...

Thank you

 

[NimeshSilva]

You're going to do a big mistake
You'll realize after somebody cut their hands
Pls don't supply directly to the solenoids. Polar engineers have taken lots of effort to make sure your safety. Don't bypass this safety. To directly supply to the solenoids, you have to bypass even the safety bolt. Thus no safety for your hands at all. This is extremely dangerous.