Polar 115 emc

[andy martin]

Hi, does anybody have a copy of the hydraulic drawings for this machine, I have a problem where machine cuts and clamps normally, but in knife change, when clamp adjustment know pulled out, clamp brought down and locks down as it should, whe trying to jog blade down it will not engage clutch, I can see clutch plate move across but not enough pressure to drive knife down. Any thoughts

 

[Grimm_Matt]

Could just be the clutch gap is too large from wear and needs shimming, I was checking where ours was at last week. I put the relevant section for that below. It says the image is the 92 but its that manual for the 115 as well.