mfc 03-3802 code?

[Swifty2]

any idea what this one is? also a message saying see controller panel ?? never seen either of these and no help available from xerox web site on codes LOL . I am doing a re-start but any info may be helpfull thanks
Jay

 

[CAignop]

input from dfe to press is delayed...
I believe

 

[peels]

hmm i think Caignop is right....Ive seen it, but never had it "stop the presses" as it were....

get it when I release a very large variable job-freeflow. sits for a sec thinks about life for awhile, then takes off.

 

[CAignop]

yea usually happends when you're processing huge files..even after dfe says its done processing the file..kinda strange

 

[Swifty2]

2 pages printed 2/2 on 2prt ncr... problem seemed to stop when I ran it as plain old 20# stock

 

[peels]

I just had it really bad on a couple of semi large postscript files. It would process fully, then sit...and sit....and sit.... extra minute or two .then whiiiiiririrrrrrrrrr goes the igen.

depends on how much different info is in the files I think. like paper type,coating,color... and maybe caching with variable data. I try to send all my files with as little info as I can. I do most of my own programming.... output setup at least. then make changes to queues. I feel like I am kind of an anomaly in that respect though. But I prefer it this way.