blade

Hello, We got a second hand machine, a Ideal 5221-90. It worked fine, untill now. When pressing the lower the clamp buttons, the clamp doesn't come down anymore. It makes the "click" of the switch, but nothing happens. When forcing it through the contactors, the clamp goes up and down. And...

Dear all, Lately, my Polar emc 137 is damaging every knife we put in place after less than 2 hours of functioning. (see picture attached below) Please advise :)

hi everyone, i have problem with my ideal 5260 paper cutter. in process of cutting both clamp and blade stuck in down position. fuses seems to be ok, overload switches (blade drive/clamp drive/backgauge drive) stick out some 4~5mm so i'm not sure if it's ok (when pressed they return to same...

Hey Yall, Not sure if this has happened to any one else, but we have a cutter where the micro adjustment keeps slipping. We'll have our new girl cutting stock when the blade goes from kiss cutting the cut stick, to absolutely chomping into it. we can reset the blade to its proper position using...

I am selling my Triumph 5551-06 EP Programmable Hydraulic Cutter includes high storage capacity programmable “EP” back gauge control module with 10 button keypad and LED display. It stores 99 programs, up to 99 steps each (up to 9 repeat cuts can be integrated into a program in a single step)...

THIS IS THE SAFEST CUTTER ON THE MARKET!! Triumph 5551-06 EP Programmable Hydraulic Cutter includes high storage capacity programmable “EP” back gauge control module with 10 button keypad and LED display. It stores 99 programs, up to 99 steps each (up to 9 repeat cuts can be integrated into a...

Not too long ago it came to my attention that the ink from the iGen is leaving residue on the cutter blade when cutting anything with a bleed. I don't recall this happening at other places I've worked, but then again maybe no ever said anything about it either. Our cutter says it's a big pain in...

I have an old Challenge Diamond 26 paper cutter. I bought it used around 10 years ago and it has served me very well. I'm not a printer, but a publisher and I do alot of my own finishing/cutting/binding of various books and such that I publish (www.opticaltoys.com). Pretty much all of a...

How do I keep steel cutter blade from rusting? With a Triumph cutter I just purchased, I was given a spare blade that was apparently just sharpened before the machine was taken out of use a couple years ago. The actual leading edge looked ok, but the rest (including 3/8" onto the angled portion...

What's the best place to have my Triumph Ideal guillotine knife blade(s) sharpened? There is no local knife/blade sharpener, so whoever I choose, the blades will be UPSed in the small wood crate so location isn't that important (I'm in Michigan)