Search results

Good afternoon, I have a Duplo DBM-400 and gatting a error code 11 meaning"The main motor rotation speed is to slow" any ideas to correct this issue, Thank you

Qm 46 second unit O.P. side, upper knob East and West, bottom North and South second unit only

Yes i do, the piston I thought he was talking about was the one inside the valve, all I wanted was the valve, that's why that is the only thing pictured any way thanks for the comments The Co. HERION and Heidelburge have exclusive rights to that valve and won't sell to anyone but Heidelburg. Its...

I totally agree, this is why I want to purchase the valve by itself, not the assembly w/ram Where would you getting these pistons if you were going to rebuild it

There is no part # Heidelburg only sells as a set hooked up to a $500.00 Ram, the ram is fine its listed in parts book Y-3 but they consider this all one piece as you can tell by pic. I can take it apart, I took two from another press

OK where can I get the piston, valve is cast, piston is plastic I cant find any parts or specs to rebuild?

It is leaking out of the ports then the compressor cant keep up and quits until you have a working pressure And Heidelburg does not sell just the valve alone!

I agree a Qm46 is a great 1or 2 color only!

that's how we have to staple these tickets, The fiery is controlling a Cannon its V7000 any help would be appreciated

I did not mean beet in just taping to go that little bit, forms 1 &2 go in fine and tight, I can turn off #3 on a long run and it helps but it comes back after 1000 impressions, the stripes looks good I have even adjusted # 3 to about 1/8 inch still no resolve , thanks for your advice

will try I can barely put the hangar shafts back in now I use a rubber mallet to get them the last 1/8 inch in!

I have over 20 years on the 3302 and can help with any questions or concerns

Have changed the bearings on the crestline and there is no end play on any forms?? Blanket is tight, plates are tight, pressure from plate to blanket are in specs, can not figure it out!!

Hello, Having problems w/3302 Roller marks about 4" from gripper running pro 3 solution have crestlines and have just replaced the bearings and pan rollers it comes and goes, if a loosen the metering roller i get to much water and the ink emulisfies. Any ideas. Thanks

I am running a 3302 and having a problem with roller marks about 4" from gripper on both heads osilater is not moving side to side and stripes are in specs, running pro 3 no additives as solution, just replaced pan roller on the kompack add enough water and the ink emulsifies, any help will be...

just about everybody I have talked too has gone with compacs or crestlines, havent found anyone that likes the hamadamatics

dont really care for it, takes to long to get color and very pickey, to dry or to wet finding the perfect ballance is very percise.

I run a H234A with the stock continuous dampening The A means it automatic (plates on/off, auto blanket wash etc).

Running 3302 with 5 roller Crestlines and the ink keeps building up on the pan roller, Pressures are correct , using silver poly fountain solution 4oz. to gallon also tried pro 3 solution same problem??