Stahl Folder Ti52 - Error 18
- Thread starter toshirohissatomi
- Start date
Freefact
New Member
- Joined
- 2022
- Posts
- 4
- Geo
- kazahstan
Hello, could you tell me what the problem is with the Stahl PD 66.T machine? There is no documentation, and I'm getting an error message saying "K section. Com. ERROR- Board 1". Thank you in advance.
Advertisement:
CHOCK
Senior Member
- Joined
- 2016
- Posts
- 3,127
- Geo
- Managua,Nicaragua
Hi Sir:
I strong recommend: Reset the CPU in the motherboard( MOBO), AND take care of regulated power supply is in tolerance, 0.7% up or down. otherwise, will NOT function for the CPU, and the machine will be always with the error.
2) clean all the edge connector in Electronic boards( this is the 75% of failure in electronic troubleshooting). ok.
Good Luck.
I strong recommend: Reset the CPU in the motherboard( MOBO), AND take care of regulated power supply is in tolerance, 0.7% up or down. otherwise, will NOT function for the CPU, and the machine will be always with the error.
2) clean all the edge connector in Electronic boards( this is the 75% of failure in electronic troubleshooting). ok.
Good Luck.
Forum posts represent the experience, opinion, and view of individual users. The Color Printing Forum does not necessarily endorse nor share the view of each individual post.
When making any potentially dangerous or financial decision, always employ and consult appropriate professionals. Your circumstances or experience may be different.
