Perfector State resets and Monitoring ... is shown after power fail or shutdown (when in perfector)

[narayan]

Hi, I'm facing the problem if SM74-8-ph machine is shutsown or power fail, upon restarting monitoring of reversing drum - storage drum syncronization is shown and have to reset perfection mode, put to straight. This happens if the machine was in perfector mode. This is fully automatic perfector machine.
I hope the machine should have been in the perfector state after restart. May be machine not storing the perfector state. There is a battery in one of the cards which might be down.
Please any suggestions.

 

[Mathew]

Hi,
Probably SAK battery has drained. It shows and error meassage in INIT code addressing S-SAK with a HEX code. Take a photo from the error message and share it with us.

 

[Adil]

Put the machine on straight mode , then reset sak , change battery if possible

 

[narayan]

Put the machine on straight mode , then reset sak , change battery if possible

Dear Adil, How to reset.

 

[Adil]

You musy shunt the two pin on the san board but i need to know which type of sak you have there is two type .

 

[narayan]

Dear Sir, I checked the board battery voltage and its 3.082 V
Attached is the board.

 

[Adil]

3v is not good for sak board ,you must change the battery first

 

[narayan]

Hello Sir, This is 3V battery. How much should be the voltage.

 

[narayan]

You musy shunt the two pin on the san board but i need to know which type of sak you have there is two type .

Sir how to reset

 

[narayan]

Dear Sir, Renata is obsolete now. Can i use other lithium cell like in this card

 

[Adil]

Hello Sir, This is 3V battery. How much should be the voltage.

It must be 3.6v

 

[narayan]

Hi, what are the consequence when we reset the SAK board. What values are reset? do we need to initialize any settings?

 

[Adil]

There is a procedure to do that regarding of your machine and sak type

 

[narayan]

Dear Adil, this is SM74-8-ph and Sak is SAK2 as i posted earlier.
Thanks

 

[narayan]

Hi, what values are reset,k when we reset the SAK board. What settings are changed? do we need to initialize any settings?

 

[Adil]

Yes there is a procedure , you must take some picture of setting and variant code before reset the sak board

 

[Adil]

And regarding of you machine type you can remove or not the ssk board

 

[narayan]

And regarding of you machine type you can remove or not the ssk board

Dear Adil can you describe more. Machine is SM74-8ph. fully automatic perfector. SAK2 board