Sm 102 perfector latching mechanism not lining up

[Jayson Yusi]

As the title says, can’t put press into perfecting because the latching mechanism is not lining up. How do I get it to line up? Only been running this machine for 4mos. Was running Komoris and Man Rolands before.

Thank you for the input.

 

[junker1984]

Date of manufacture.

 

[Jayson Yusi]

Date of manufacture.

It’s a 2007 H10. Serial number is 548179

 

[Jayson Yusi]

See how the lines are off by an inch?

 

[Jayson Yusi]

:

 

[junker1984]

Do a site search on here, there was recently a long thread going over “re-zeroing perfector changeover error” or something like that. It went over the procedure for the task you need accomplished.

 

[Jayson Yusi]

Seems like the hydraulics are not engaging.

 

[junker1984]

“Oil can error” showing at unit equipped with perfector? Plug going to intensifier?

 

[junker1984]

By the way, it’s not going to do anything until zero position is restored.

 

[Jayson Yusi]

By the way, it’s not going to do anything until zero position is restored.

Yeah it’s stuck in straight print. The latching mechanism is not lining up. How do I reset it so the lines line up?

 

[Jayson Yusi]

“Oil can error” showing at unit equipped with perfector? Plug going to intensifier?

 

[junker1984]

Like I said earlier, search this site for re-zeroing procedure of perfector. It’s involved, and I don’t have the time to go over it on this forum.

 

[Adil]

You have to check first the hydaulic oil is not enough , then pneumayic pressure of the machine , if all is ok yiu have to set the machine manually on the straight mode