Can conductivity be measured with a ppm meter. I'm using house water with conductivity of 175/200. At 3 oz per gallon of etch reading 375 after...
I have water swings from one side to another after starting run, maybe 100 to 150 sheets in. Which is what book describes about chrome roller not...
The only thing shady about settings is the form to Chrome setting, having a variable strip because of rollback book says.
...yes I get that. If it was something mechanical it wouldn't be same problems in both units, right?If I had a dollar for everything I reset I...
New ink and dampener rollers 6 mths ago. Dampening problems ever since. Also company changed to Kodak on press developing plates and different ink...
yes Turbotom,I agree. Unfortunately its where it seems to run best. Problem is we put a new set of rollers in and changed plates to Kodak self...
Thanks Jack, my press is not blessed with that accessory.
Thank you so much, I'll give it a try next week. By the way, I run normally 10%-12% alcohol . also do you use ph strips or a conductivity meter?
Thanks, I could be incorrect but I believe the crown is 10 or 12 thousands. I know they are crowned because when setting the center definitely...
Problem solved, thanks for all the info.
Good morning all, I am having issues setting the dampening system for short width jobs on this press. when setting the water pan roller the...
Thank you for the info. This compressor feeds to a water seperator before entering the press. Its mounted inside panel beside the feeder. Built in...
Thanks Jack, I pulled the compressor out. I removed the air plug on the end of the tank and drained about a qt of water out, that told me at least...
I am having problems with this compressor, DURR-TECHNIK, K15, runs all the time. This press is 15 years old and I have had many air leaks and...
Hey, I dont know diddly but I would try changing occilation timing a few degees. put the streaks in cylinder gap??? or if you can change...
FYI After having all these water issues Steve you got me wondering. I was fairly confident the water rollers were set ok so this morning I removed...
Check the first fitting on top of tank, it has a screen in it. It would be the Blue line. Or its calcium, do you use distilled water?
Thanks for the advice, Ill look into that.
The adjuster for #14 water form on the operator side has no resistance,but seems to adjust. Is it possible the adjusting screw has come out of the...