Search results

That's at double feed operation. Single feed is different

Thank Joe, checked at 268.

Thank you I'll try this in the morning

What degree should the indeed wheels be set to touch 1997 SM 52- 2 Thanks

Running a 2001 SM 52. this last week started having movement issues with 2nd unit circumferential register. hairline adjustments may move much more than intended and takes too many sheets to recover on the fly so must shut down and start over with MR. These movements are only while press is...

Assuming rollers are set correct, water and ink, check your water mixture. Read the label, start with recommended mix. Check your alcohol mix. Should be around 8 to 10 percent. Also your inks cannot be too soft. Easy check put some ink between thumb and forefinger. Tap together and pull apart...

Maybe it needs lubricating . Possible it backed out too far and exited the adjuster..I would pull everything out and start over. Don't be afraid to set all settings on th lighter side. Instead of 4 or 5 mm try 3 to 4. Make sure everything is backed out equally. Get some kind of penetrating...

If you look at end of motor which has a flexible end cap and can remove it you will find the brake mechanism. Possibly just needs cleaned and lubricating. Worth a try.

Hey guys having an issue with compressor reaching kickout point. kicks off when starting press but cannot keep up, also only reaches 8.5 bar. does drain water when kicks off. I'm thinking leak somewhere in press but I cannot detect any or hear any leaks. Any ideas?

Sorry I must of missed that reply, and it makes sence

Got it, a breaker was thrown that apparently powers the motor function. I forgot the red bar signals all is well. It was in green position which I thought was good to go. Thanks

if anyone has a schematic of the grease gun for SM52 ,pointed nosel, I would appreciate it. Cannot figure how this gun goes together and make it work. Thanks in advance.

Screen looks normal except for that the press degrees are not there. Also as I stated the voltage is low fluctuating between 2 and 5. I suspect main power board problem.

Not showing any errors but voltage is only showing 5

Good morning, Powered on SM 52 this am press will not move. everything is normal and press alarm rings but press will not engage. In creep mode the alarm rings and motor will click two times but not engage. Any help will be appreciated. Old School 52

Anyone have a diagram of a push pump Heidelberg grease pump. Found one but cant make it work maybe missing parts?? unable to fill it correctly.

Can conductivity be measured with a ppm meter. I'm using house water with conductivity of 175/200. At 3 oz per gallon of etch reading 375 after adding 6% alcohol, reading in ppm. It's not the same as measuring microhos??

I have water swings from one side to another after starting run, maybe 100 to 150 sheets in. Which is what book describes about chrome roller not being centered on meter roller. S3002 is a two step. Running 3 oz per gal at 6 % alcohol. Water reads 200/250 depending on day, 420 to 460 typically...

The only thing shady about settings is the form to Chrome setting, having a variable strip because of rollback book says.

...yes I get that. If it was something mechanical it wouldn't be same problems in both units, right?If I had a dollar for everything I reset I could retire.