Search results

I have a PM52 that is printing ok but when the Numbering unit is installed, we note that the numbering unit doesn't go into impression. note the photo that when we press in lever it doesn't go in even after pressing it aggressively. what could be causing this to happen? please advise.

Please provide advice on this model CRON 3624 G+

Morning to all, Please help. Our panther pro 46 is our work horse in our prepress but we have noticed that we put in a new film and the length of the file is shrunk about 1/2" but the width is accurate. Has anyone experienced anything like this before. please advise

We just invested in the P7000 CTP from Presstek using a Epson 7000 printer on the JT plates. Can anyone advise on using these plates on a Heidelberg GTOV Alcolor press. We disconnected the transition roller but we need advice also on getting the right calibration between plate making and press...

Good day all, please advise what is the purpose of the hole that is identified in this Photo. Its the Toner Supply Sub Assembly Pump. we are experiencing a toner supply issue that the print had a reduced color due to toner shortage. we cleaned and checked the supply hose and allis clean but the...

Good day everyone, we had worn needle bearing on the holder on the pincer bearings which we replaced but I had only marked the Operator side as I haven't had any experience on this removal and after removal I noticed that there are two separate gears and I had only marked one. Now I am having...

Does anyone know what could be causing my machine to be in stop mode as 2 of the five light are not coming on in the perfecting unit as everything seem to check out, any electrical diagram would help as we got this unit used. Thanks for your help

Please advise as my operator has made the star wheel bar loose and it got caught and the delivery grippers are not straight anymore as the chain delivery can be seen as twisted as right side chain is more advanced into machine about 3' away from the other side. I don't want to loose anything...

someone Please help, we have been supplying printed material to banks that has them printed with Drop Out Inks that is to guide the customers to write in a particular area but will not be show on the scanned copy. we need to have a tester or some error free method to check the density so that...

Help, We have a Polar 90CE serial Nr.412281 that is experiencing problems as it was cycling sometimes, now it has stopped. We were told to that the #8A and #9 Board was bad so we purchased these which wasn't cheap and after putting them in it is still not functioning. A technician is saying it...

Please assist in advising where I can source Black carbonizing ink in small quantity such as 5 kilos as I have a unusual request. India is too problematic, I need a US source rush. any assistance is greatly appreciated. Thanks

Please assist, I have gotten a Graduated disk but cannot locate a WLM 113 gauge block. can any technician post a picture for me and can we correspond so that I can get some advice on its use....thanks

Please advise on a program that we can use to number sequentially in various colours on Linoprint C751 digital Press. We have tried the program NUMBERING MACHINE PRO but it doesn't print the PDF image and number at the same time, either one or the other prints.

Greetings, please advise on best way to change transfer gripper needle bearings NK18/16ASR1 on our 1998 GTO 52-2-P. The 2 sides of the shaft is moving so both the bearings are bad, I guess the overuse of wash down solution that has fallen on the shaft over the years has taken its toll. We have...