Help with Xerox DC12

[charford]

I have recently purchased a xerox dc12 with fiery x12 rip and would really appreciate some help/advice. The machine is in good condition with low click count and has been serviced all its life by xerox. My intentions are to use it for very low print runs and as a back up machine.
The rip is running software version 1.1 and I can't find drivers anywhere, does anyone have them? Operating system that I am running is windows xp or i could also use mac 10.5 or 10.6, although windows xp is preffered.
Alternatively I could update the software on the fiery to v1.5 if anyone has a copy that they would be good enough to give me?? This way I could use the drivers available on the xerox website.
Also, if anyone has any advice regarding command workstation and what version I need that would be appreciated. I think I need version 4 but can only find version 5.
Thanks in advance!

 

[eldoret]

Dc12

I have recently purchased a xerox dc12 with fiery x12 rip and would really appreciate some help/advice. The machine is in good condition with low click count and has been serviced all its life by xerox. My intentions are to use it for very low print runs and as a back up machine.
The rip is running software version 1.1 and I can't find drivers anywhere, does anyone have them? Operating system that I am running is windows xp or i could also use mac 10.5 or 10.6, although windows xp is preffered.
Alternatively I could update the software on the fiery to v1.5 if anyone has a copy that they would be good enough to give me?? This way I could use the drivers available on the xerox website.
Also, if anyone has any advice regarding command workstation and what version I need that would be appreciated. I think I need version 4 but can only find version 5.
Thanks in advance!

I have been using DC12 for past 5years and found to be an excellent printer; do still have your copier?

regards,

Vijay

 

[eldoret]

I have been using DC12 for past 5years and found to be an excellent printer; do still have your copier?

regards,

Vijay

 

[InterfaceP]

Did you try http://www.support.xerox.com/support/docucolor-12/downloads/enus.html?associatedProduct=fiery-x12&operatingSystem=winxp&fileLanguage=en

Make sure you select Windows XP. Xerox no longer supports DC 12

 

[InterfaceP]

I regret helping you.

I see you asking for help a lot but never have the decency to thank anyone.

None of us are compensated for the time we spend helping people like you.

 

[MarkD]

Since the OP is over 15months old are you surprised?

3 posts asking for help - hardly "alot"

Plus there is a TIA

--
Mark

 

[InterfaceP]

Since the OP is over 15months old are you surprised?

3 posts asking for help - hardly "alot"

Plus there is a TIA

--
Mark

Three is a lot. More than once is a lot.

I learned my lesson, in the future I'll check the user before I help.

 

[sir007]

Xerox DC12 diplay Message: Power on the machine

Hi,
i recently installed a xerox DC12 and Fiery x12 rip running with Windows NT.
I installed all drivers and software( Commande Workstation, ...).
I can't do print test from the fiery.
When i choose the LP1 port and try a print test from the fiery, i receiv the message: the device is not ready.
The DC12 diplay the message: Power on the machine
I understand that the printer can't show the machine
there is any action to do, to make the DC12 communicate with the fiery?