polar 76em

  1. whats is this component and its value?

    I have a three TAM card for the machine polar 76EM where i find that, the PCB is burnt and i'm not sure whats is this and its value(green color small rectangle shaped) someone can tell me the value of this component, it would be appreciated. please check the picture for the component burnt. Here...

  2. Polar 76 EM keypad not working

    Hi In our machine polar 76 EM there is a different problem we are facing, first we had some unknown error as 9.31.1 then we rectified by changing the AR and IAR board but now we are facing another problem is that, we can type the numbers from keyboard for the input measurement and after if we...

  3. polar 76 EM error code

    Hello my dears, I have an issue in polar 76 EM machine which displays code 29, I'm facing this problem since one month and I'm looking for an aid from Colour printing forum. please help me in this problem to get rid of it. with regards, siraj

  4. Replacing the Safety bolt on an polar 76em

    Hi guys, We finally went ahead and bought a used polar 76em, 1985 Its been working beautifully so far,10 hours a day/single shift. other than few errors and blown fuses its held up pretty well. i managed to break the safety solenoid thanks to operator error right now, I need some help...

  5. Help about POLAR 76 EM: How to adjust the Back Gauge?

    Hello dear Sir. How do I should adjust the back gauge to get it parallel to the blade? Thank you very much

  6. Polar 76em

    Polar 76 EM Year 1990 With Cutting program Blowing table Safety photocells Maurizio Capone Elektrospeed maurizio@elektrospeed.it mob. +393450592397
Back
Top