Graphics Board may be problem
Well, CP6 board was faulty.
Is it ok to test the CP6 and GC card in older machine or vice versa?
Polar 78Xt is not booting. Display shows nothing. After power on the display is white which turns black gradually. Backgauge not moving and knife...
Thanks for reply. The brake lining is dry, no oil. Should i check gearbox (worm gear)? what should be the air gap?
Hi I'm experiencing knife afterrun in Polar 78XT. I tried adjusting air gap of Magnetic clutch and brake. What should be the gap thickness? Any...
This is Fully automatic perfector machine.
In Perfection, the gripper assembly is very complicated. Gripper opening cam, Storage drum reversing drum, sensors, hydraulics, hydraulics clamps...
Hi I'm having this Problem recently . Moinitoring of reversing drum - storage drum synchronization. The Machine is SM74 8 color 5PH. Previously it...
The motor commutator and brush may not have good contact because of oil and carbon dust. cleaning it will solve most of the time.
The filter is beside the D pump. Its at Y type Splitter. You unscrew the cap and take out filter, clean and it should be OK. Is the problem...
Did this error just came suddenly or did the problem for some motors already exist?
Which size is your machine? There are 2 sizes 10x15 and 13x18 and both have different saftey mechanism. 10x15 has saftey collar at back side below...
We tried to run the machine after long time of stoppage. The machine is not functioning. The machine displays '4000' which is speed and '0' at...
Laser printers can print on transparency or polyester plate but the registration is not perfect. They shrink or expand and sometimes it is not...
Well it turned out that the cable on the delivery side swinging control panel was loose. Tightened it and problem solved. Thanks.
Hi, Heidelberg Stalhfolder 66 KD 2004 model is not booting. It is restarting while booting into operating menu. Display show Heidelberg...
Hi we have been using this old machine since 4 years and about million impression die cut. Now the impression pressure needs to be set high (about...
Does the paper always rip at same place? Check the Impression and transfer gripper tip at that place. May be needed to adjust or replace the...
After long time i found that the new fan would spin at full speed when pos and neg 24v are supplied and pwm signal is absent. This fan's speed is...