Search results

Hi Chock, Thanks for replying, No the machine will not start. The machine is set to use a warning bell before being able to start. The reset seems to set up a control circuit before starting. Let me know if you need further info Willycom

Does anyone know how the reset circuit works on the Komori L225b. We have checked all the safety trips on doors and things like paper detector at the delivery table and the delivery table full switch. All motors including the main motor by switching the contactors in the circuit box and the air...

Actually Chock I did leave the 16 tooth on the machine but have not looked at how many teeth on the pulley the 50 Hz power supply required. I just took a guess at the time thinking that the machine may have had the pulley which was meant for 60 hz. AS it turned out the machine was running slow...

Thanks for your help thus far Chock. We have done as you suggested. Setting up the height of the trays. It is hard to say whether this made a lot of difference. The machine still miss-fed often. We went through all the tray pressures and changed the pressures of the friction pads to a lower...

Hello Mr Super Chock, Thank you for your reply. It does make sense that the machine is stopping the feed because the sheet is not reaching the sensor in the specified time. This is a direction I had not thought to look at. Will let you know the outcome when I have checked these things. Thanks

Wondering if anyone has had a similar problem to this. We have a Duplo DC10 mini that will not feed any of the bins correctly. The problem at first was intermittent and then became bad enough for us to stop using the machine. The main board has been replaced without resolving the problem. The...