Search results

It does sound like an ink water issue,i agree with aqazi81 if you have another ink laying around try running it. If that doesn't help try a fountain with a little gum in it.

Also it might be a good idea to bring along a tech you trust to look over the equipment along with someone who has run it before or at least the pressman who will be running said equipment. Two eyes are better than one as they say.

So I'm going to pose a question for you. Where does your business model take you in 1,3,5,7 and 10 years? This may determine which piece of equipment is right for you. Now with that said you also need to take into account finishing and plating.(along with manny other variables) Is it the right...

The sanco universal works very well with these. You can also move it between presses. The other benefit would be the amount of stock you can load at one time.Im not sure who sells them anymore however.

I would check the gripper pads first, then the gripper shaft that holds the pads.It seems if the pads are slightly worn on these it tends to double the length of the sheet.make sure they are in adjustment and the pads are not worn out. That would be the starting point.

HI, here in ohio lots of shops have gone under or merged . The one problem we are having is finding qualified people anymore.Ten years ago you set an ad in the paper and 40 people applied now we are lucky to find 1 person who might have some clue.Things are busy still however. The other issue we...

Try calcium remover next time.It seems to remove the excess gum quickly.

I have seen the e 5 code as the main power switch going bad also.

This is something i will look into further. Thanks for the advice. I'm sure its much cheaper than pouring a new pad.

That could be another route to take. I'll have to look into it. What gauge steel are you using ? Is there other problems that have arisen from doing this? What about rolling skids across it ,does it catch them or is it a smooth transition?

Rolandman so many times things are over engineered as we all know. Thanks for the advice. Those small problem seem to always be the worst on almost every machine I've worked on. The price of the machine is basically rigging and install . We need to pour a heavier floor as well. The only room in...

That's a good resource to have. I know the tech I have looking into this equipment has a check list . It isn't that involved so I might forward this onto him. Thanks again

Thank you yeslek , this is exactly what I'm looking for. I have someone looking into the machine next week. It comes from someone we have done business with in the past so I trust them more than just a random sales person. I think the machine will be a good fit so I wanted to know what to watch...

That article was good thank you aqazi81.

Hello, my company is looking into buying a used man roland 300 after research. My questions are more geared to operation and how user friendly it is. We have 2 other 4 colors so that end isn't new or anything. I'm looking to find more up time so the questions i have are as such,are parts easy to...

You're welcome.

Can you move the gto operator over to the qm for a day or so ?

You could try to cut your baseline on that machine by 10 % before you toss a bunch of money at it. If he's running saturated and dumping water to fight it .

So i just had an issue with another type of press but it was doing a similar problem.It wasn't an press problem but an operator error. The operator is a trainee going from heavier coverage to lighter without sheeting down. He was using the water at a higher speed to compensate for the over...

Check the end play in the water rollers.