Search results

100+ fonts in calif. Case drawers in cabinets, 3 Chandler & Price (2-22", 1-18" w/foot powered shaft, converted), 1 Little Giant 18", chases, quoines, parts, tools, rollers, etc. The smaller hand-feed C&P is run often with variable speed, others need rollers & have Rice auto-feed units, motor on...

Hey Saic, yes, controls the plate to blanket bounce by spring adjustment(just below the arrow). I adjust "by eye/ear" but haven't the need in many years. Tell-tale would be the plate wearing out before specs, considering fountain is correct. Nice clean press - I grease those springs.

hey Fear, take off operator side cover and observe gear, latch, latch glide, spring and travel bar(s) table height section. Sometimes the screw holding the latch glide to the frame loosens so the latch won't catch the gear properly and consistently. The travel bars are your pile height detector...

Only on the operator side, 2 grippers tear the sheet but only 2 of the three gripper bars do this. I've replaced the gripper finger pin(s), adjusted the open/close timing of the fingers, hammer driven the gear side chain-drive gear pin, different settings on the gripper release adjustment at the...