Search results

Getting this error on startup. It can be cleared and run for straight 4/0. Concerned that if we switch into perfecting mode there will be a problem. Not much guidance in the book, sensors appear to be clean and functioning. Thinking it could be the limiter on the NOP side? Anyone ran into...

3 tower setup on a Horizon Stitchliner 5500. tower #3 the trays will rise for calibration & feeding, but do not drop down once empty. They will return to the starting position if the towers are powered down. We are not getting any error codes, thinking it could be a faulty sensor. Anyone...

Currently running an older Horizon Stitchliner 5500 now past end of service life... looking at the Duplo I Saddle to replace this, mainly on cost factor alone. New Horizon Markiii , 400k & up versus the Isaddle 250k price tags. Looking for some real life input on the Isaddle

We currently are running 2 canon image presses, 1 oce vario print 110 & 14 x 20 offset (straight 4 color, no coater) in our shop. Floating the ideas of moving into B2 indigo or a 7k press. With either move we will either eliminate offset altogether or start that transition with the 7k. How...

My operator came to me with an issue I have not seen before. Running a 07 524 GXP, were running CMYK, all units are turned on. However randomly when starting up unit 2 will not engage but units 1,3 & 4 will. Then another time during the day Unit 3 was not engaging while 1,2 & 4 will. This...

Looking to add an envelope feeders to our 524. Having issues finding a machine that is compatible with Ryobi. Anyone use a good envelope feeder for Ryobi offset?

Anyone ran across E-8 error in the third unit.

random occurrence today. Up and running at 10,000 on 14 x 20 100# gloss cover. Started getting some doubles toward the bottom of the stack. No biggie, Reloaded and kept doubling. Checked the feeder and the separator blowers (2 inner blowers) were not blowing air. Main blower getting air, aux...

Experiencing some recent feeding issues, and looking to replace the sucker feet. Which we have yet to do on our 524 since the press was installed in 2020. Have the correct feet, noticing the old suckers are quite difficult to remove and would hate to damage. Is this common?

Currently running Canon Imagepress 8000 for color & VarioPrint 110 for B&W. We are experiencing a lot of down time on a monthly basis. Looking moving to Indigo press when our lease runs out. Two main concerns I am coming up with, outside of the cost increase. Do you need to run Indigo...

recently purchased a 524 gxp. great machine. Had the touchscreen replaced on the pcs-h and now there is a pinpad coming up to go into service mode. Any ideas what the code is?