Ryobi 524 P Error on startup

[Chris Goff]

Getting this error on startup. It can be cleared and run for straight 4/0. Concerned that if we switch into perfecting mode there will be a problem. Not much guidance in the book, sensors appear to be clean and functioning. Thinking it could be the limiter on the NOP side?

Anyone ran into this before and offer insight

 

[CHOCK]

Hi Sir:

Using the press for a long time , without changing the status printing system from : straight to perfector system: CAUSE insufficiency of lubrication oil at each part of the press !!!!
Therefore the status of printing , must be switched periodically ...!!!!!

The press display a message for to remember the operator . !!

 

[Chris Goff]

Gotcha...we have not switched it over in a few months....neither I or my operator have seen it before... correct me if I'm wrong, grease the perfecting unit and other points, oil tank is half full and this should go away right?

 

[CHOCK]

That is correct !!!!