Recent content by Printerdroid

iGen 4 Having issues with bad toner bottles. When the machine calls for toner and you put a new bottle in it may run for awhile but then will call for new toner as if it was empty. Error message says its out of toner and stops the press. Switched to a different bottle and its good leaving me...

That is a great suggestion! If I understood you correctly: I changed the value to "true" for the max value and it's been running so far so good! I may have enough stock left to finish the job. :) Thanks for the info!!

The clip looked OK and everything seemed like it was seated in position. It was worth a try! Thank you for the info!

XPE-09-3061 , 09-3066 Transfer Detack Fault Too bad you didn't find out for sure what the root cause was. I'm having the same 150 problem: with transfer detack issues for a couple weeks now. Checked the TAB blade screws, replaced TAB blade (on our third TAB blade now) replaced the Dicors, ...

Thank You for the quick fix! XPE-09-3066, XPE-09-3061 :) Thanks CargoPantsMan for the quick fix! Re: XPE-09-3066, XPE-09-3061 Replaced the usual suspects: transfer /detack dicorotrons, reboot, & total shutdown etc, w/ no effect. It was the TAB blade screw all along........ My 150 was...

I would say it shows up immediately. The log lists the fault as: Charge 2 (Y) AC HVPS missing DC input voltage. which would indicate a power supply issue or perhaps a controller or (distribution) board issue.

Has anyone had any experience with this iGen4 fault code? XPE-09-4052 Looks like a power supply issue. Any ideas? also getting XPE-03-4017 code in addition to the first. (this one is a M ROS issue from previous posts in the forum).

It works!! Thank you for the fix! I had the very same problem: replaced the thermistor assembly and away it went. I believe it was part #130K74530.:cool: