Recent content by Don Prints

Found one, but thanks for the reply

AB dick Specs say 1,300 lbs with T head

I just bought a Rosback Model 220 True Line Perforator at an auction and it is a little rusty. I am in need of an operators manual and parts list, so i can get this up and running. I would prefer a PDF that you could email me, but beggars can't be choosy I will pay for copies and shipping if...

If your still looking! Log onto wirebids.com they have at least 1 auction a month you can pick up a ryobi 3302 and platemaker for less than $5000

Lantz whats your email and i'll send you service manual, Parts manual and electrical manual in pdf.

Hey Ziggy check out http://www.wirebids.com/ if no auction up yet Call:Boggs Graphics - (440) 564-9675 Ask for Chris or Jack and let them know what you are looking for, they just had one on the auction that ended on the 8th Boggs Graphics Equipment LLC 9988 Kinsman Road Novelty, OH 44072...

Still Looking

Bump;

I have a Multigraphics SP 990EI giving me Error Code 4 Error in Voltage Compensation of Exposure Time What do i need to fix this problem? I have another Platemaker i bought for parts. I have called all the graphics Dealers in the Cleveland Ohio Area and there are no techs for this machine.I...

Thanks Ryobiserviceman I was checking for power with one of those buzzing light up probes, When i checked with a meter i was only getting 32 volts from one of the legs. I borrowed a switch from another printers parts press and it did the trick. Thanks again Don

Went to start up today and all was good for about 30 seconds, and then no power no lights no fan. I have 220 volts at the plug in, When i turn on main switch there is nothing,usually the fan would start. I checked the main switch and it has power when turned on. Is there a main fuse i'm missing...

Ziggy Sticky is not a pressman and he's never run process before, so he had better have something to line up to. He's not going to use a densitometer to read values, it would just be good for him to keep his ink even and have someplace to start registering to. I've been running presses since...