SPK 000F Code Error and SLT_CON 7FF1 CD102 F+L

Please Help,
I have a problem with CD102 F+L.
DYN - TEST
SLT_CON 7FF1 Error
INIT - TEST
SPK 000F Error

Best Regards!

 

Spk ( if you have sak /sak2) in main panel then spk error have no meaning.

For slt error
1) check fuses to main drive
2) check supply at drive input.
3) on physical measured value is ok then check at cpt display value if main motor input voltage.

 

Hi sir;
for Init Spk error;
*Check:
Very low battery voltage ( < 3V DC ) .

In SLT_CON 7FF1
*Check:
Low voltage detected at L1
Low voltage detected at L2
Low voltage detected at L3

 

- SPK 000F
It means that the battery voltage and lower than 3v

- Slt_con 7FF1
This means that the voltage detected on L1, L2 and L3 is low (low voltage)

 

Hi sir, there are 2 batteties (3V and 5.5V)
Kindly advise which one are you refering to?

I have a similar problem:

SM 74 is showing error 15 with SPK 000F or SPK 0000 which sometimes goes away and comes back after a few minutes (whilst running or when stationery).
Kindly assist

 

Hi Sir:
Happy New Year
If You have 2 batteries, first measure
With DMM,(digital Multimeter)
A) if the battery for 3Vdc, Is lower , Replace inmediately, you have only 10 minutes x to do it, otherwise you lost the information.
B) Proceed in the same with 5Vdc, if Is lower yo 5Vdc, replace6 it.

Very important, Replace battery, with equal6 specification, like Lithium, etc.

Let me know, sincerely

Blessing