Ryobi 3300 CA ERROR 14

[shekar_msc]

Recently I started working on a used Ryobi 3300 CA machine (Single Color Press with auto plate loading attachment removed). A new Blanket was fixed by removing the old. After which the Machine is Displaying ERROR 14. Press is stopped. No Run or Inching command is accepted.

What is Error 14 in Ryobi 3300 CA, How to get the Press running again. Anyone Please Advise. Thanks in Advance.

 

[CHOCK]

Is the error coming from Inverter??

However ,Please test the output of the inverter to the main motor if is coming.

If not coming , test the input from the inverter that is coming.

3) By other side, clean very well ,all the Edge Connectors from electronic boards,( this is cause of most of 85% of electronic failure)./

Blessing

 

[shekar_msc]

Is the error coming from Inverter??

However ,Please test the output of the inverter to the main motor if is coming.

If not coming , test the input from the inverter that is coming.

3) By other side, clean very well ,all the Edge Connectors from electronic boards,( this is cause of most of 85% of electronic failure)./

Blessing

Inverter is Ok, otherwise E-3 error would have been displayed. But Machine not accepting start command or Inch fwd/rev command.

 

[CHOCK]

No, i did indicated you very explicit:

1) test the output +input inverter voltage, did you do?? since your machine is NOT accepting signal for inch/forw/rev is a good condition for that you test the inverter, please.

2)By other side, clean very well ,all the Edge Connectors from electronic boards,( this is cause of most of 85% of electronic failure), did you do??

Blessing