Registration sensors

Discussion in 'Xerox iGen3 & iGen4 Digital Presses' started by peels, May 17, 2017.

  1. peels

    peels tree killer :)

    Joined:
    Dec 2010
    Messages:
    952
    Location:
    southeast iowa, usa
    Currently dealing with a skew and misregistration problem, as well as an error with a registration steering motor: "inboard steering motor power saturation" it is random and occasional, growing more frequent. however, I also noticed the #'s in the registration sensor monitor are high again.

    My curiosities are:

    how difficult is it to change that motor?

    is there a baseline of number that the registration sensors should be at, maybe I have a wonky sensor again?
     
  2. Milo Wilson

    Milo Wilson Senior Member

    Joined:
    Dec 2007
    Messages:
    355
    Location:
    Arkansas
    Which sensors and what are the values? The steering motor might have a bearing that is going out.
     
  3. peels

    peels tree killer :)

    Joined:
    Dec 2010
    Messages:
    952
    Location:
    southeast iowa, usa
    CCD's and reg sensors. 1-4,5-7 (i think) Not exactly sure. if you open component control/reg sensors, you can click through them. I had a troublesome one once, that I Had to do that to clear jams for awhile. It had a very high value of 192. One of them now also has a very high value again at almost 200, so I'm curious if theres an acceptable range.
     

  4. Milo Wilson

    Milo Wilson Senior Member

    Joined:
    Dec 2007
    Messages:
    355
    Location:
    Arkansas
    I would definitely replace it if cleaning doesn't work.
     
Loading...

Share This Page