Printing 2 Part or 3 Part NCR on an iGen4 or iGen5

[CMOOREPRINTS]

I have only been running both an iGen4 & iGen5 for about a year and a half now. Is the iGen4 and/or iGen5 capable of running NCR?

 

[CargoPantsMan]

It is. It just requires a bit more planning.
Are you using pre-collated stock or individual loads?
Is it variable or static?

 

[CMOOREPRINTS]

Pre-collated stock.
Static.

 

[CargoPantsMan]

Shouldn't be too big a deal then. Just set the stock type to ordered with the number of parts so the IGen can recover from any jams correctly.
Also, make sure your contact arc is even. That thin NCR stuff can crease pretty bad if things are cock-eyed. And the decurler settings may need some tinkering with. But overall, not too bad to run.