Power Troubles

Discussion in 'Xerox iGen3 & iGen4 Digital Presses' started by peels, Apr 13, 2017.

  1. peels

    peels tree killer :)

    Joined:
    Dec 2010
    Messages:
    953
    Location:
    southeast iowa, usa
    Came in to "press fault-restart" today. no EU noises.

    mutiple reboots, never initializes. Took off back, power supply on the left, red LED indicating "OV" I'm assuming that's "over volt"?

    killed all breakers a few times, only boots to initializing screen.

    just tried boot with EU and breakers off. Psip comes up!!! but with faults, of course. flip on EU breakers. nothing, then OV and press fault. im over it. called in service.

    brand new EU still causing me a headache. LOL
     
  2. peels

    peels tree killer :)

    Joined:
    Dec 2010
    Messages:
    953
    Location:
    southeast iowa, usa
    Solved: two problems.

    bad power supply and...

    EU problem, the main power cord at bottom of EU was partially unplugged!

    EDIT: had the power supply with red light on again.

    so only the EU issue solved.


    back to square one.
     
  3. peels

    peels tree killer :)

    Joined:
    Dec 2010
    Messages:
    953
    Location:
    southeast iowa, usa
    down for 4 days now. the whole time....

    its been our power. gotta watch the meter like a hawk, shows all legs there....but as everything boots, it overdraws as each system turns on, lowering the voltage for a moment. we got it running briefly, by moving the breaker boxes. but then "cooling down" came on. So I tried to run with box fan wind tunnel..and you could see/hear the fan slow down! 120v circuit the fan is on dropped to 15 when EU attempted to run.

    waiting on a new Bus Bar.
     
Loading...

Share This Page