Polar 92 EM

Hello,

We have a Polar MOHR 92 EM from 1987 year. (Pict. 1)
After starting on the center display appears, in the middle, a red dot.
1. If I press the handle the backgauge is moving, detect the refference point , change the moving sense and after short time change the speed and run fast forward and hits the end.
The positioning display shows only the central dot and + or - at the right side, depending on the direction of backgauge movement.
No errors shows on display.
2. If I press "=" on keyboard and acces programms the display looks like in the pict.2
From arrow buttons I can move the backgauge forward and backward.
3. On trying to use it in manual way if I press the pedal the clamp come down .
When I press the both cut buttons the knife doesn't move.
The IR barrier works, the led change from red to green and reverse if an obstacle is in the protection range of it.
4. If I press both cutting buttons without pressing the foot pedal, the clamp moves fast down and noisly hit the table.

Here , I think that is more than one problem with the equipment.
Any help will be appreciate.
Thanks and regards,
Peter.

 

The problem is that the blade delay is switched on and you have to turn it back until the red led is off.
it is the rotary knob with the green dot.

Best regards

Bert van Gompel

 

Hello Bert,

Thank you for the advice.

Best regards,
Peter.

 

This solved the clamp and knife problem.
Thanks again,
Peter.

 

Hello,

I need bin with V2.0 version from AR card. It is in one 27128 Eprom.
Or I can send my bin if someone can check and compare this version (V2.0).
Thanks and regards.