Polar 137 emc monitor

Discussion in 'Cutters and Trimmers' started by D4rkThanatoS, May 7, 2015.

Page 2 of 2
  1. D4rkThanatoS

    D4rkThanatoS Member

    Joined:
    Dec 2010
    Messages:
    22
    Location:
    Lima
    Not activ (Y315) the cut. 42VDC = 0 volt.
     
    D4rkThanatoS, May 10, 2015
    #21
  2. Coloured paper

    Coloured paper Senior Member

    Joined:
    Oct 2012
    Messages:
    258
    Location:
    Germany
    Do you have 42VDC
     
    Coloured paper, May 11, 2015
    #22
  3. D4rkThanatoS

    D4rkThanatoS Member

    Joined:
    Dec 2010
    Messages:
    22
    Location:
    Lima
    No 42 vdc.
     
    D4rkThanatoS, May 11, 2015
    #23
  4. Coloured paper

    Coloured paper Senior Member

    Joined:
    Oct 2012
    Messages:
    258
    Location:
    Germany
    On the left side you have the transformer. There fuses as well. Please check the fuse F4 (4 Amp slow) and measure between pulg 403 pin 5 to plug 403 pin 2. You have to have at least 45 V d. c.
     
    Coloured paper, May 12, 2015
    #24

  6. D4rkThanatoS

    D4rkThanatoS Member

    Joined:
    Dec 2010
    Messages:
    22
    Location:
    Lima
    Si 42.5 VDC.
     
    D4rkThanatoS, May 12, 2015
    #25
Page 2 of 2
Loading...
Similar Threads
  1. DMonninger

    Polar 137 emc monitor: need steps to set correct cam/switch positions for s22a/b

    DMonninger, Jul 27, 2023, in forum: Cutters and Trimmers
    Replies:
    0
    Views:
    398
    DMonninger
    Jul 27, 2023
  2. rich8606

    Polar 137 EMC display replacement

    rich8606, Dec 19, 2022, in forum: Cutters and Trimmers
    Replies:
    3
    Views:
    1,330
    Ali zengin
    Feb 1, 2023
  3. melvin barrera

    polar guillotine 137 EMC, static failure in cutting field

    melvin barrera, Jun 8, 2022, in forum: Cutters and Trimmers
    Replies:
    0
    Views:
    2,604
    melvin barrera
    Jun 8, 2022
  4. willatclampitt22

    Polar 137 EMC-MON

    willatclampitt22, May 17, 2022, in forum: Cutters and Trimmers
    Replies:
    5
    Views:
    816
    CHOCK
    May 19, 2022
  5. Mouad

    Clamp of my Polar emc 137 not moving up

    Mouad, Nov 24, 2021, in forum: Cutters and Trimmers
    Replies:
    0
    Views:
    936
    Mouad
    Nov 24, 2021