Lifting rear suckers and governed foot not working

Discussion in '1-Color and 2-Color Offset Presses' started by cc1433, Oct 31, 2019.

  1. cc1433

    cc1433 Member

    Joined:
    Nov 2010
    Messages:
    39
    Location:
    Sri Lanka
    Hi,
    As of this afternoon my MOZP printing machine is faced with the issue where, the rear suckers don't have suction and the governor foot doesn't blow air.
    I checked,
    • The pnuematic controllers switch on and off on the DS controller.
    • The suction is abit low, it's at 4.
    Any suggestions?
    Regards,
    Charith
     
  2. NotAGooner

    NotAGooner Senior Member

    Joined:
    Dec 2007
    Messages:
    252
    Location:
    UK
    Fuse on the compressor?
     
  3. turbotom1052

    turbotom1052 Senior Member

    Joined:
    Oct 2008
    Messages:
    744
    Location:
    Vermont
    check all air lines from the compressor to the feeder head for good connections and or leaks
     

  4. cc1433

    cc1433 Member

    Joined:
    Nov 2010
    Messages:
    39
    Location:
    Sri Lanka
    There was a piece of muck stuck in the feeder head, and when we removed head, I realized that piece was jamming the head and that's why the vacuum only coming from the front suckers.
    Thank you.
     

    Attached Files:

Loading...