I changed the faulty EAK card - the machine displays disturbance Q44

[wandeyiz]

thank you friends
on the machine the present lubrication system is the grease system.

 

[ashok kumar]

Hi
As per conclusion.
Machine is sm74-4 low pile.
( since machine with low pile and 4 or less four unit comes with grease lubrication.)
Now in varient code
011 value is n ( in bottom it shows sm74)
231 value should 1
232 value should 1

Or pls send me pix for all varient pages.
I will confirm the right codes

 

[ashok kumar]

Check attached pixes.
Still your varient key are not rights as per my opinion

 

[wandeyiz]

thank you
here are the variant key screenshots

 

[Adil]

To change the parameters of a variant key, you must enter service mode to have control

 

[wandeyiz]

New
thank you
here are the variant key screenshots

 

[ashok kumar]

Hi
Varients code seem ok.
Only think you can now do is reset the sak2(basic intailization)

 

[Adil]

Switch off the press
Raise the control console plate
Connnect the button to connecctor EAM-x12 slot 7
Switch on the press
Actuate the buttton the service display variant code appears
Compare the variante code in the display with the printout or your Own notes
If necessary ,move the cursor to the required position with the right hand +- buttons , with the left hand +- buttons the value can be modified
Switch off the press , wait a few seconds ans switch on again

 

[wandeyiz]

thank you thank you friends,
I reset the SAK card, and the problem is solved
I remove all the wires that I connect to the machine, now it runs normally without any noise, and the lubrication system has returned to grease lubrication,
thanks again

 

[ashok kumar]

Great

 

[Adil]

Bravo