Heidelberg QM46 2

[Langton]

1)Guys i have a problem i need urgent help.QM46 was running and doing washup and suddenly it stopped.I discovered that one delievery gripper broke and i removed it ,now i discovered that my delievery grippers are now off timing as they cannot pass through the impression cylinder when inching the machine so now i jumped the chains by tooth by one tooth forward and now timing is fine but now machine cant feed paper and on SF 56 there error 1 11-07 so i need help if i did the coorect setting on chains or how do i rest that error l know its double sheet detector sensor at feeder but how do i clear it.
Thanks in advance for your help
Langton

 

[CHOCK]

Hi sir:
you must sure from this:

1)
The zero position of the press 0° is determined by
pinning the impression cylinder to the side frame.

2) A distance of 37.6 mm must be adjusted between
screw-on surface of the gripper bar and the lower
edge of the cam follower of the cam lever

3) Status code means:
Press stops and sheet is under the electronic eye of
the double sheet detector (VD). You must test the 2 steps before, and then Fix it this.

 

[Langton]

Thanks very much for the i am going to try it and give feedback.

 

[CHOCK]

OK, sir