heidelberg printmaster 46 Unit 2 wont insert plate at clamp

Discussion in 'Heidelberg Printing Presses' started by Mark1125, Jul 16, 2018.

  1. Mark1125

    Mark1125 Member

    Joined:
    May 2017
    Messages:
    14
    Location:
    Ohio
    will not take the plate at clamp spring is at 5mm
     
  2. CHOCK

    CHOCK Senior Member

    Joined:
    Dec 2016
    Messages:
    1,579
    Location:
    Managua,Nicaragua
    Hi Sir:
    1) Check condition and easy motion of guide rollers: Cleaning:check and replace if necessary
    2)check plate loading and ejection function and reajust if necessary
    check condition and function of friction rollers
    check distance of feed rollers and guide plate to plate cylinder: Check and cleaning.
     
  3. Mark1125

    Mark1125 Member

    Joined:
    May 2017
    Messages:
    14
    Location:
    Ohio
    Do u happen to know the special funtion code to use to manually isert at tail clamp? Thank you
     
  4. Raphael Khumalo

    Raphael Khumalo Member

    Joined:
    Jun 2016
    Messages:
    6
    Location:
    HARARE, ZIMBABWE
    We have a similar problem with the second unit. It does not hold the plate for long. Plate slips out during run. Is there anything we can do to resolve the problem?
     
  5. CHOCK

    CHOCK Senior Member

    Joined:
    Dec 2016
    Messages:
    1,579
    Location:
    Managua,Nicaragua
    Hi sir:
    You can do the same procedure:
    Hi Sir:
    1) Check condition and easy motion of guide rollers: Cleaning:check and replace if necessary
    2)check plate loading and ejection function and readjust if necessary
    check condition and function of friction rollers
    check distance of feed rollers and guide plate to plate cylinder: Check and cleaning.
     
  6. Leon Patterson

    Leon Patterson New Member

    Joined:
    Sep 2020
    Messages:
    2
    Location:
    York PA
    All guards closed, then S3+7, then 13
     

  7. CHOCK

    CHOCK Senior Member

    Joined:
    Dec 2016
    Messages:
    1,579
    Location:
    Managua,Nicaragua
    Hi sir:

    What did happen ???

    1) Check condition and easy motion of guide rollers: Cleaning:check and replace if necessary

    2) check plate loading and ejection function and readjust if necessary

    check condition and function of friction rollers

    check distance of feed rollers and guide plate to plate cylinder: Check and cleaning.

    Let me know

    Blessing
     
Loading...