Heidelberg Plate Control Strip help

Discussion in 'Platemaking' started by sornchai, Jul 13, 2021.

  1. sornchai

    sornchai Member

    Joined:
    Feb 2017
    Messages:
    5
    Location:
    Bangkok THAILAND
    Hi.
    I' m from Thailand. I can't find how to read meaning this zone on plate control strip when under or over developing or exposure.

    Thank you for your kindness
     

    Attached Files:

  2. ashok kumar

    ashok kumar Senior Member

    Joined:
    Nov 2017
    Messages:
    178
    Location:
    india
    In center it triangle should be merged.
    If triangle is not merge in center then plate is either under develop/expose or over Delovped/expose depends which side triangle is merging
     
    sornchai likes this.
  3. sornchai

    sornchai Member

    Joined:
    Feb 2017
    Messages:
    5
    Location:
    Bangkok THAILAND
    Thank you sir. Merge mean same as backgroud ? My picture is merge or unmerge? Please explain more again
     
  4. ashok kumar

    ashok kumar Senior Member

    Joined:
    Nov 2017
    Messages:
    178
    Location:
    india
    Hi
    In your picture, triangle is merged in second left.
    It should be merged in center.
     

    Attached Files:

  5. sornchai

    sornchai Member

    Joined:
    Feb 2017
    Messages:
    5
    Location:
    Bangkok THAILAND
    I see. Thank you very much sir.
     

  6. ashok kumar

    ashok kumar Senior Member

    Joined:
    Nov 2017
    Messages:
    178
    Location:
    india
    Also note these stirps will work properly with prinect workflow.
    If you are not using prinect workflow then it will never come
     
    sornchai likes this.
Loading...