GTOzp s 52 2 Mother board

I'm looking to replace this 98.144.1101/01C. I'm not able to get past the Heidelberg sign display on the screen. It just seems to hung. Anyone out there has one that i can purchase.

 

Please go to the representation Heidelberg in his country
Otherwise you have the Risk, in to get Wrong EPROM with firmware and CPUmicroprocessor

 

Fellow members i am unable to get my machine a gto 52 2 zps past the Heidelberg display in other words its not initializing thus i have no access to the console. Anyone out here who can assist. The local Heidelberg technician here doesn't seem to understand the problem.

 

Hi sir:
Normally is your machine has Display with LCD, you must test
+24Vdc at the display.
Is your machine having cptronic too?

 

Yes it has cptronic will upload a screen shot of the screen display.

 

Sir:
You must test the +24Vdc.
When your turn On the machine the Micro Processor or Cpu, as self Diagnostic indicating if the Processor is o.k
2 reason can happen;

1) Missing or faulty power supply +24Vdc
2) Motherboard ZSK is faulty.

However do this:
A) Perform a visual inspection : look for loose and broken wires, improperly seated connectors, loose or broken wires
misset switch, missing jumpers. and so on.
Chech for obviously damaged component(components burned or discolore due to overheating);
Dust + dirt + tear +wear

B ) Reseating Boards and components:
Edge connectors are a common souorce of problems. Power down the system and remove the PC boards. Examine the edge connector
for contamination and clean with contacts cleaner contacts. Reseat any loose components 9suc as scoketed ICs) . Reseat the
boards and power up.

 

Hi,
Having had a technician check the machine the problem has been isolated down to the ZSK board any leads on who does repairs or where i can get a used/second hand board.