Feeler fingers and stack height

Discussion in 'Ryobi Printing Presses' started by Center Printing, Oct 9, 2018.

  1. Center Printing

    Center Printing New Member

    Joined:
    Oct 2018
    Messages:
    1
    Location:
    Bradenton, Florida
    I am running an old Ryobi 2800 lately the paper is jamming in the feeler fingers. I can run it with the feeler fingers in the up position and have no problems unless I get a misfeed then I just clean the back cylinder and get back on running.

    But For some reason, the paper stack is just too high and I cannot get it to lower anymore. I know the height adjustment but I have that all the way down and the stack is still too high.

    Any suggestions would be helpful.

    Thanks.
     
    Center Printing, Oct 9, 2018
    #1
  2. Ryobi Press Parts

    Ryobi Press Parts Member

    Joined:
    Dec 2011
    Messages:
    55
    Location:
    Indianapolis
    Hello, I know what the problem is, I can help you diagnose the problem if you would like to call me.

    Regards, Paul
    Ryobi Press Parts
    517-881-7114
     
    Ryobi Press Parts, Oct 12, 2018
    #2