itsme
New Member
- Joined
- 2014
- Posts
- 1
- Geo
- Tennessee
I'm trying to figure out how to tackle a current project of mine. I have a very tiny image(1cm x 1cm) i'm trying to use as a sign for an RC project.
I've been printing transparencies out of a HP laserjet cp1215 but they don't print opaque enough to fully keep the light out and show only the image i'm trying to backlight.
Usually i'll print a few copies and use registration marks on each page to line them up but it's very tedious and i know there is a much better way to approach this. I've read something mentioning foil but can't get good information on it.
Can anyone else shed some light or ideas?
I've been printing transparencies out of a HP laserjet cp1215 but they don't print opaque enough to fully keep the light out and show only the image i'm trying to backlight.
Usually i'll print a few copies and use registration marks on each page to line them up but it's very tedious and i know there is a much better way to approach this. I've read something mentioning foil but can't get good information on it.
Can anyone else shed some light or ideas?
