BosRot
Member
I have a problem with the Baumuller Motor on our Heidelberg MO
The motor is overheating and the thermal cut-out is activated after 2-3 hours of use.
My electrician has inspected the motor and all seems ok :
internal fan extracting ok
brushes new
commutator good
brake releasing correctly
However the motor star/delta connection seems incorrect. It seems to be in a Delta connection (200v) at the moment but should be in a star connection (380v) as the machine has a 380v supply.
I am unsure if the connection is correct and how the configuration of the bridging plates must be to change it to a star connection, if it is delta at the moment. (pls see attached photos)
Motor details: (pls see attached photos)
D type
Type : RDNX 27Z-L4
Nr: 92101515
Any assistance / advice is greatly appreciated.
The motor is overheating and the thermal cut-out is activated after 2-3 hours of use.
My electrician has inspected the motor and all seems ok :
internal fan extracting ok
brushes new
commutator good
brake releasing correctly
However the motor star/delta connection seems incorrect. It seems to be in a Delta connection (200v) at the moment but should be in a star connection (380v) as the machine has a 380v supply.
I am unsure if the connection is correct and how the configuration of the bridging plates must be to change it to a star connection, if it is delta at the moment. (pls see attached photos)
Motor details: (pls see attached photos)
D type
Type : RDNX 27Z-L4
Nr: 92101515
Any assistance / advice is greatly appreciated.
