Bad side 2 toner adhesion

[Kiran04]

Leads to this. Any ideas why? Already found a snapped set of screws on the external roll nips and replaced them. Still piss poor adhesion.

 

[Milo Wilson]

Did you do External heat roll nip adjustment after replacing the broken screws?

 

[Kiran04]

Of course. Even did a web adjustment. Maybe I'll just pop in a new fuser roll and see how that does. I've also recently replaced the pressure roll, but I made sure to make that adjustment as well.

 

[peels]

check the donor/metering rollers.

 

[Kiran04]

check the donor/metering rollers.

Done external rollers. The metering roll doesn't even have an adjustment.

 

[Kiran04]

No improvement on this front. Found a few more cracked parts, but the machine still doesn't adhere toner properly. It scratches off with ease and builds up on the rollers. Also a heat error when starting up, XPE-10-3111. No idea the cause.