Airtech powder system on QMDI-Classic

[Steevo]

advillarrealc@email.com or whatsapp +57 311 496 0404.. can write me

That bounced. Is that the correct email address?

advillarrealc@email.com
host mx01.mail.com [74.208.5.22]
SMTP error from remote mail server after RCPT TO:<advillarrealc@email.com>:
550 Requested action not taken: mailbox unavailable

Reporting-MTA: dns; filter03.reliabledns.org

Action: failed
Final-Recipient: rfc822;advillarrealc@email.com
Status: 5.0.0
Remote-MTA: dns; mx01.mail.com
Diagnostic-Code: smtp; 550 Requested action not taken: mailbox unavailable

 

[augustov]

That bounced. Is that the correct email address?

advillarrealc@email.com
host mx01.mail.com [74.208.5.22]
SMTP error from remote mail server after RCPT TO:<advillarrealc@email.com>:
550 Requested action not taken: mailbox unavailable

Reporting-MTA: dns; filter03.reliabledns.org

Action: failed
Final-Recipient: rfc822;advillarrealc@email.com
Status: 5.0.0
Remote-MTA: dns; mx01.mail.com
Diagnostic-Code: smtp; 550 Requested action not taken: mailbox unavailable

not is advillarrealc@gmail.com Gmail...

 

[jan]

i think the problem is not the knob
.. because S04 is turn on the motor is only a pulse.. tte knob is a mechanical system for drain vacum air and blasting.. so isnt mechanical and not power motor, is maybe a electronic mistake from.the press.. that maybe dont turn on the motor or make a power fault when all system work... i will check if exist any code with S3 7 15 because maybe is sheet monitoring desactive or problem with the TSK...

Hi Richard,
as Augustov has said: look for channal output 100, (SF 3+7, 15 than 100)
100 OUT, SVK3:X31-1 Solenoid valve, powder spray device, Y32.
You'll understand your problem. There is no controll of quantity of spray by the system, it's only on/off regualtion, due to the timing from the sheet's
length controll. Reduction of spray quantity is made manualy by the knobs: left middle and right, and with the big one for common reduction.
S04 is turning Y32 on and you see spray comming out.
Due to the wrong sheet's length controll, you are probably getting only short impuls on Y32 (0 turn to 1) during printing.
rgds
Jan