metal

Dear Friends, We have found this forum as an easy for using resource and well discoverable in the internet, in comparison with other engines in similar fields. It would be nice to extend this forum, or to grate a separate one, as to Maintenance, Servicing, Control & Automation of other...

Looking for input from anyone using the JT Direct inkjet metal plates imaged on an Epson printer. I got some test plates from Mark Andy/Presstek/ABDick that they had made with a test print pattern and they performed well when I tested them. So I bought a dozen or so from a local printer friend...

Hi, anyone using one of these inkjet metal CTP systems on here? I stumbled across something where plates were 'imaged on a standard (17-inch) Epson inkjet printer which was controlled by a software RIP to produce halftoning and separations etc. Once 'imaged' (ie printed upon), you can then...

I am new to running a Presstek 9995C press with polyester plates. Large solids with small reverse type inside is difficult. On heavy custom order card stock with 75% ink coverage I have a hard time keeping it open. The press can't seem to run 120 or 130 lb stock fast enough. The owner tells...