Search results

yes, but it doesn't move out of position... that is, it always stays on and the zero position light doesn't turn off. It was supposed to have the B53 sensor, but this machine doesn't have it and I can't identify how it is positioned

The unit completes the cycle, but the cylinder does not stop at the correct angular position, ending up slightly out of reference (off by a few degrees). In other words, the cycle finishes, but the cylinder is not correctly synchronised for plate change. This behaviour is consistent only on the...

3 units: 130mm varnish pump membrane part number : 00.785.0001 / 01 € 75 the unit

packaging with 100 units of suction cups ... 100 €

be possible to give me the information on which to stretch the tension of the cauchus speedmaster 52, 74 to 102 and 52 Gto. thanks

good day. can someone give me a copy of a manual of training course of printing the Print Media Academy. Thank you all for availability.

want to print 0.75 at ROLAND505 ???? but ... these machines are not ready for it!

hello. what I understand from your e-mail, do you want to hit the drums. the top with enferior.Correct? then goes through the following: two plates is equal. defines the edge of the "start" 5.5 or 6.0 cm. then prints the 1st body, sets the margins. on the motor side, you have a cover...

yes ... I am of the same opinion. save money for a GTO ... but Alcolor system.

A few millimeters. usually see is the this: if the job hits the crosses and then when it starts with the work he gives a bad record. always in the circumferential direction. become the right without stopping the machine, he'll get right to the end. the problem is always the machine...

good. I think you should do is: 1. will have to have the leaves all the same pad measure, 1.05 +1.95 micons of rubber. 2. make plates for all bodies with millimeter or checkerboard 5x5mm in the format 50x35. 3. print one color at a time and check with the film over the print to see...

Hello everyone. I have been doing some assists to 52 sm in the print area and lately has appeared error 14. does not affect anything on the run, but also can not get disqualified. someone can give me a hand?

hello. I fully agree with what he says. There is much concern about the Ph, but many people are unaware that commodities are buffered. ie the use of a buffered product, or use just the right amount or more 1 / 2 L. will always give the max value. 5.3 + - , which is unaware that are...

hello. GTO exists on the machines at the wheel of a record ciscunferencial small circle with four screws. loosen all the bolts before removing to a risk they may check the current position. will then remove the piece off and stick your finger to see if there ferugem. if there will be a...

dit is 'n enjin probleem. Brake / koppelaar.

Hello everyone. I also had some problems like this. after several tests performed, the ink that behaved better in every type of substrate and low / high speeds was Vanson sonafresh. I have helped. ps. I do not know if your machine has cooling coils. if it keeps the theoretical value by...