What is the file size? May be you can use the Google Drive ?
Thank you !!! Can you send it by e-mail ? lvivltf@gmail.com
Thanks in advance My e-mail - lvivltf@gmail.com
Hi ! We are looking for one page of circuit diagram - unit +AD, page "Mains unit remote disconection" (Roland 705 3B - 1992). There are some...
Hi Roland 705 3B (709 series). We have a new problem. On the second section, the plate cylinder mechanically moved by 4 degrees against the zero...
Hi Drukman! There is a picture with rollers in the attachment. The rollers 11.4 and 11.5 are absent. We have only 402, 21 and 31 rollers. But...
Hooray !!!!! I have fix this problem (16-5-0-0-0 SPS: Uberdrehzahl Feuchtduktorantrieb DW 2) ! It was a driver (A381/2) for the Water Fountain...
Hi ! I have a Service Training Elektronic .pdf file (Communication system). As I understand - I need a service set for testing fiber optic cable,...
Hi ! Today the errors with Prozess-Bus occurred again. There are a pictures of errors screen (prozess-bus) and status of moeller fiber optic...
At the moment Roland is in normal working order. These errors are not stable. They occur unpredictably. I need to catch the moment of error and...
What inverter are you talking about ?
Moeller
Thanks for your reply. Of course I'll check fiber optics. I did not pay primary attention to these prozess-bus errors because they appear after...
Thank you very much for your help. At first I replaced the motor and the sensor. Yesterday I replaced input card 7, DA converters 8 and 9, -A397...
Hello We have the next error that occurs periodically only when the system loading (see attachment - first error). As I understand, NODE 9 is...
Thanks. I'll try it. Also I found the next block -A397 on a board -A383 (see the attachment). It transfer the signal from the dampening solution...
Hello ! The situation looks so: 1. I replaced the motors between section 2 and 4 (with magnet and speed sensor) 2. I replaced the dampening...
Hi to everybody Sometimes we have the next problem on printing - stripes or waves (see the attachment). This is electrical or mechanical problem...
Thx ! I'll try to change this motor between the section 2 and other one. If the problem with this motor - the error will be at other DW. I think...
Dear Drukman Are you talking about the M101 engine (photos in the attachment)?