Search results

what you need is an air blower motor,not a compressor...

Have you tried asking for help from mitsubishielectric?

as i see rather is a dampening problem than bad ink roller settings...i suggest to make sure the ink-water balance is ok...also check ph and conductivity...increasing little more the ink feed and less water you shoul solve the problem (increasing IPA also might help )

I might help you,pm me...

All of the power suppliers were verified and only one of 5v were bad (and is hard to tell the real cause because this happened once before at the owner before us because it wasn't the original power supply)Regarding to installation it is possible that i was not following the right steps.The...

Unfortunatelly there is no good tech in our region,but finally we found one of the 5v power supply failed.After replacing the 5v PSU and some investigation we found RIC2 and all three RIC1 boards were bad.So at this time we managed to buy RIC2 and two RIC1 but there is one error left related to...

another day,same problem...any suggestion?

It is about a L640 from 1997 with serial nr 2088.We had to replace on PQC the 5V power source,so we did and now we have error code 702-606-605...in this order

I have several issues with my PQC on L640. Is there anyone could give me all of error codes for the PQC ?

problem solved .thank you!

I did>And now i got "KMS operation panel error "...so what's next ?

Recently i got this message on the KMS monitor."KMS - PLC communication error". Any suggestions where to start searching the problem? I have to mention that i have changed the battery on the KMS pc motherboard since then i got this error.