Search results

  1. Change anilox SM74 year 2005

    dismantle both sides carefully everything is in your way......take out old anilox.....place in new anilox....assemble everything back in original position...check nip width...enjoy printing...

  2. Hangtag 24pt with Gluing, PP Matte Laminate and UV Spot

    If paper streching is you problem maybe you should change paper grain direction

  3. Hangtag 24pt with Gluing, PP Matte Laminate and UV Spot

    gluing should be the second step if laminating and UV is possible at that thickness,or die cut for centre and holes has to be the last step, but make sure overlapping the white is perfect

  4. Hangtag 24pt with Gluing, PP Matte Laminate and UV Spot

    since overlapping of two sheets is not perfect ,die cut can't be neither...

  5. communication between PQC with KMS

    first check if com port configurations are ok

  6. E 17 error, moving guide manually on L-640

    Also might be clogged thread...check ,clean,grease.Fine adjustment is possible changing sensor position but not recommended

  7. E 17 error, moving guide manually on L-640

    deacivating the side lay from the console you are able to move it by hand with a knob fitting on that hole near that small gear

  8. E 17 error, moving guide manually on L-640

    E17 is overrun error.The home position sensor should stop the side lay preventing this to happen.

  9. Komori lithrone g40 feeder sensor trouble

    first make a visual check...photocells must be lit ,clean of dust then manually insert a sheeet of paper covering photocells and with a non coductive (plastic) screwdrive set sensitivity (from white potentiometer )individually, following the red-green leds indication

  10. Horizontal stripes

    take some good pictures and upload

  11. Water gathering behind plate

    That is condensation ....reduce difference of temperature between press and ambient

  12. Need Help! Komori sprint II 26 cam positioner parameter was cleared!

    which model of Varicam you have?

  13. uv ink

    Conventional UV; High power consumption High heat output Wider range of UV light 200 - 400nm wavelength High press speeds Requires external cooling, air or water. Lamp life about 1000 hours Wide range of ink's, varnish's and coating's Creates ozone Hazardous light output, must be shielded Must...

  14. Color Registration problems in my Komori L 428 year 2000

    one option would be getting through impression your paper stock before print

  15. aux. motor clutch

    air cylinder sensor ,problem solved...thank you

  16. aux. motor clutch

    forgot to mention. 1997 L640 press

  17. aux. motor clutch

    APC errror lit,continously ringing,motor clutch won-t disengage. Resetting the press wont help,neither switching on manual. checked PLC X013 X014,no LED lit. Need help ASAP

  18. no x-rite hardware key

    recently i had to replace the pc from the PDC.And after installing all softwares when i'm opening the PDC-S software i got this "no x-rite hardware key installed" message unable to open it. It's about a L640 press with PDC-S ,PQC III...any suggestion is wellcomed...

  19. Parts Manual

    what type of press you have more exactly?

  20. Doubling on Gear Side Guide

    looks like i'm not the only one with this problem...it happened to me twice same screw at the same unit...
Back
Top